USD 
-
Gear wheel - 902034 for speed gearbox for lathe SV18R and SV18RA. Shaft II: 902018 -
Gear wheel - 902035 for speed gearbox for lathe SV18R and SV18RA. Shaft II: 902018 -
Flat belt glue for SV18R lathes. Composed: glue 100 g hardener cement K 20g -
Set of plates for lathe SV18RA. -
Coolant pump for machine tools. Immersion depth: 250 mm. Power supply: 3x400V. Degree of protection against fluid penetration: IP 54. Parts of the motor are made of non-flammable thermoplastic material in accordance with the following standards: VDE 0730 and UL 94. Low weight and dimensions, excellent technical parameters together include an ideal solution for cooling the cutting processes of machine tools. Maximal fluid temperature: 65°C. -
Coolant pump for machine tools. Immersion depth: 100 mm. Power supply: 3x400V. Degree of protection against fluid penetration: IP 54. Parts of the motor are made of non-flammable thermoplastic material in accordance with the following standards: VDE 0730 and UL 94. Low weight and dimensions, excellent technical parameters together include an ideal solution for cooling the cutting processes of machine tools. Maximal fluid temperature: 65°C.
-
Hard outside jaw SCV for chucks TOS SUPERIOR. Ground clamping surfaces. Set of 4. Sold in sets. -
Hard outside jaw SCV for chucks TOS SUPERIOR. Ground clamping surfaces. Set of 3. Sold in sets. -
Hard inside jaw SCN for chucks TOS SUPERIOR. Ground clamping surfaces. Set of 3. Sold in sets. -
Short taper flange IUS-B/5 DIN 55027 / ISO ISO702-III / ČSN ISO702-III. For chucks: IUS, IUSO, IIUH. IUHO. Available sizes: - 160 mm - 200 mm - 250 mm - 315 mm -
Flat belt - unconnected for lathes SV18R. Width: 100 mm Available lengths: - 1990 mm - 2340 mm - 2360 mm Other lengths on request. -
Live centers are determined for workpiece chucking in lathes or to work in grinding machines, especially by the grinding workpiece higher weight. The construction of live centers features with small diameter head of tip, allow easy access tool to the workpiece. Live centers with cone MK 2 ÷ 6 is possible adjusting clearance in front of radial bearing. Live centers have shank with cone MORSE according to ČSN 22 0420 (DIN 228, ISO 296) without clamping thread. Available sizes: MK1 MK2 MK3 MK4 MK5 MK6 -
Block 703463 for clutch for speed gearbox for lathes: - SN55, SN63, SN71 - SN400, 500, 630, 710 - SUI40-50 Required quantity: 2 -
Shear pin 806084 for thread cutting gearbox for lathe SN32, SN40-SN50 and SN55-SN71. -
Oil filter reduction and lid complete for speed gearbox for lathes SN40, SN45 and SN50. Used to replace the old type of filter 803266 for the new type 813019. See our blog about filter replacement.